Hoshizaki KM-150BAF-E Installation Manual Download Page 3

Page: 3 / 36

91U1TB10A9907

• This icemaker must have a separate power supply or

receptacle of proper capacity. See the Nameplate. It
is recommended that this icemaker be the only
electrical device on its power supply circuit.

• Usually an electrical permit and services of a licensed

electrician are required.

• Factory fitted power cords are coloured in accordance

with the following code:

Green & Yellow = Earth
Blue = Neutral
Brown = Live

• Should the socket outlets in the installation site not be

suitable for the plug supplied with your product, the
plug must be removed (cut off if it is a moulded on
plug) and an appropriate plug fitted.

As the colours of the wires in the power cord of this

appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:

The wire which is coloured Green-and-Yellow must

be connected to the terminal in the plug which is
marked with the letter E or by the symbol or

coloured Green or Green-and-Yellow. The wire
which is coloured Blue must be connected to the

terminal which is marked with the letter “N” or coloured
Black. The wire which is coloured Brown must be
connected to the terminal which is marked with the
letter L or coloured Red.

If the non-rewirable plug has been cut from the power

supply cord, it must be disposed of. There should be
no attempt to reuse it. Inserting such a plug into a
socket elsewhere presents a serious risk of electrical
shock.

For the U.K. and the Republic of Ireland only

• The non-rewirable plug must never be used without

a fuse cover being fitted.

• The correct replacement for the detachable fuse cover

is identifiable from the manufacturer’s reference
number stamped on the plug.

• Supply of replacement fuse covers can be obtained

from Hoshizaki Parts/Service Centres.

• Fuses should be rated at 13A and approved to BS

1362.

ENGLISH

3. The location should provide a firm and level

foundation for the equipment.

4. Allow 15 cm. clearance at rear, sides and top

for proper air circulation and ease of

maintenance and/or service should they be

required.

5. This appliance is not suitable for installation

in an area where a water jet could be used
and where dripping is not allowed.

6. Do not place anything in front of the Louver.

7. This icemaker will not work at subfreezing

temperatures. To prevent damage to the
water supply line, drain the icemaker when
air temperature is below zero.

4. INSTALLATION

• The installation must be carried out by qualified per-

sonnel, in accordance with current regulations,
according to the manufacturer’s instruction.

• Incorrect installation can cause harm to people, ani-

mals the icemaker, or the installation location, for
which the manufacturer cannot be held responsible.

1) Unpack the icemaker, and attach the four adjustable

legs provided (optional) to the bottom of the Storage
Bin by lifting the front of the icemaker and then lifting
the back of the icemaker (DO NOT TURN THE
ICEMAKER UPSIDE-DOWN).

2) Position the icemaker in the selected permanent

position.

3) Level the icemaker in both the left-to-right and front-

to-rear directions by turning the Bin Leg Adjusters
with a wrench.

4) Replace the panels in their correct positions.

5. ELECTRICAL CONNECTION

WARNING

THIS APPLIANCE MUST BE EARTHED

This icemaker requires an earth that meets the
national and local electrical code requirements. To
prevent possible severe electrical shock to individu-
als or extensive damage to equipment, install a
proper earth wire to the icemaker. Turn off the power
supply before any maintenance, repairs or cleaning
is undertaken.