3
C. Location
CAUTION
1. This icemaker is not intended for outdoor use.
Normal operating ambient temperature should
be within 45°F to 100°F (7°C to 38°C); Normal
operating water temperature should be within
45°F to 90°F (7°C to 32°C). Operation of the
icemaker, for extended periods, outside of these
normal temperature ranges may affect icemaker
performance.
2. This icemaker will not work at sub-freezing
temperatures. To prevent damage to the
water supply line, drain the icemaker if the air
temperature is going to go below 32°F (0°C). For
details, see "II.C. Preparing the Icemaker for Long
Storage."
For best operating results:
• The icemaker should not be located next to ovens, grills,
or other high heat producing equipment.
• The location should provide a firm and level foundation for
the equipment.
• Allow 6" (15 cm) clearance at rear, sides, and top for
proper air circulation and ease of maintenance and/or
service should they be required.
I. Installation and Startup Instructions
WARNING
1. This icemaker must be installed in accordance with
applicable national, state, and local regulations.
2.
CHOKING HAZARD:
Ensure all components,
fasteners, and thumbscrews are securely in place
after installation. Make sure that none have fallen
into the storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping
container and immediately report any damage
to the carrier. Upon opening the container, any
concealed damage should also be immediately
reported to the carrier.
• Remove the shipping carton, tape, and packing
material. If any are left in the icemaker, it will
not work properly.
WARNING! Keep packing
material (plastic bags and expanded
polystyrene) away from children.
• Remove the panels to prevent damage when
installing the icemaker. See "I.B. How to Remove
Panels."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels.
If the icemaker is exposed to the sun or to heat,
remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch
lines or other surfaces.
• Check that the compressor is snug on all
mounting pads.
• See the nameplate on the side panel, and check
that your voltage supplied corresponds with the
voltage specified on the nameplate.
• This icemaker can be installed on a storage bin
48" wide or wider. For options, contact your local
Hoshizaki distributor.
• On remote air-cooled model, a remote condenser
unit is needed. Hoshizaki Remote Condenser
Unit, Model URC-14FE is recommended.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the 2 screws. Lift up and
towards you.
• Top Panel: Remove the 2 screws, then lift off.
• Side Panel (R): Remove the screw. Slide forward
slightly and lift off.
• Insulation Panel: Remove the thumbscrew. Lift up
slightly and pull towards you.
• Top Insulation: Lift off.
Fig. 1
Top Panel
Insulation Panel
Side Panel (R)
Top Insulation
Front Panel
Summary of Contents for KM-1301S J-E Series
Page 35: ...35 Intentionally Left Blank ...