20
III. OPERATING INSTRUCTIONS
WARNING
1. This icemaker is designed to produce and store edible ice. To keep the
icemaker hygienic:
* Wash your hands before removing ice. Use the plastic scoop provided
(accessory).
* The storage bin is for ice use only. Do not store anything else in the
bin.
* Clean the storage bin before use (see “IV. 1. PERIODICAL
CLEANING”).
* Keep the scoop clean. Clean it by using a neutral cleaner and rinse
thoroughly.
* Close the door after removing ice to prevent entrance of dirt, dust or
insects into the storage bin.
2. The use of any electrical equipment involves the observance of some
fundamental rules. In particular:
* Instances of high humidity and moisture increase the risk of electrical
short circuits and potential electrical shocks. If in doubt, disconnect the
icemaker.
* Do not pull the power cord in order to disconnect the icemaker from the
feed network.
* This appliance is not suitable for unsupervised use by young children
or aged or infirm persons.
3. All parts are factory-adjusted. Improper adjustments may result in failure.
4. If the unit is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
5. Do not put your hands into the back of the storage bin or the ice chute
on top of the storage bin. Ice may drop off the icemaker, a hard block
of ice may suddenly break down, or the icemaking mechanism may
suddenly move, resulting in injury.
1. START UP
1) Disconnect the power supply.
2) Open the water tap.
3) Connect the power supply and energise.
Summary of Contents for IM-240ANE
