Hoshizaki HFE-140B Series, Service Manual

Page: 32 / 52

2
To set the mode setting number:
) Turn off the power supply.
2) Hold down the two Temperature Control Buttons and turn on the power supply. The
Temperature Display Window will show “0”.
Note: This is not the preset model number.
3) Use the Temperature Control Buttons to indicate the desired model number.
Note: Do not select “00”, or further settings will be made unavailable. When “00” is
selected by mistake, turn off the power supply and go back to step 2).
4) Press the Reset Button for more than 3 seconds. The Temperature Display Window will
flash “rc”.
5) Press the Reset Button again for more than 3 seconds. The Temperature Display
Window will flash “oF”.
6) Turn off the power supply.
To check the model setting number:
1) Hold down the Set Point Button and turn on the power supply.
2) The Temperature Display Window will illuminate and show the model setting number.
(The Compressor will start 0 seconds after this button operation.)
Model setting number: 1D (HRE series: Off-cycle defrost)
0D (HRE-F series: Heater defrost)
29 (HFE series)