45
8) Remove the evaporator cover (and the heater cover with the heater bracket).
9) Remove the defrost thermistor from the evaporator.
10) To replace the removed parts, reverse the above removal procedure.
Note: 1. See Notes 1 - 5 for “[b] COMPRESSOR”.
2. Be sure to replace the defrost thermistor in its correct position.
3. After servicing, use putty to seal the pipe through-hole in the cabinet.
4. When disconnecting the evaporator from the heat exchanger, use a wet towel to
protect the wires from burner flame.
2. ELECTRICAL PARTS
[a] CONDENSER FAN MOTOR
1) Pull out the condenser and condenser fan motor assembly according to steps 1)
through 4) of “[b] COMPRESSOR”.
2) Disconnect the condenser fan motor leads.
3) Remove the screws securing the condenser fan motor to the bracket, and take off the
condenser fan motor.
4) To replace the removed parts, reverse the above removal procedure.
Refrigeration
Unit Base
Heat Exchanger
Evaporator & Heat Exchanger Joint
Exhaust Duct
Intake Duct
Evaporator
Defrost Thermistor
Interior Fan Motor
Assembly
Evaporator Cover
Summary of Contents for FTC-120MDA
