6
WARNING
: do not push or drag the counter during installation or in the future, in order to prevent it from
turning over or damaging its parts.
WARNING:
Do not place the cabinet in the vicinity of heat/ignition sources or in
environments with high temperatures and/or highly flammable materials.
Set unit in its final location.
Be sure there is adequate ventilation in your room. Do not allocate equipment to
environments above the declared climate class.
Remove protective film from product.
This may cause unpleasant static electricity discharge which, however, is not
dangerous.
The inconvenience is reduced or prevented by continuously holding the appliance with
one hand or grounding the package.
It is now possible to level the counter by adjusting its feet.
During leveling, slightly tilt the counter towards its back to allow for a better door
closing.
Clean with lukewarm water and mild detergent (as described in the chapter ‘CLEANING’) and assemble the
accessories available.
Check the correspondence of the mains voltage with the one indicated in the identification plate of the
counter.
WARNING
: check that the mains outlet is provided with grounding. If not, arrange it.
Insert the plug into the outlet.
The counter must be incorporated into an equipotential system that must be checked for
efficiency according to the regulations in force. The connection must be carried out by
means of a screw marked as ‘Equipotential’ located in the compressor area.
The installation is now completed.
GENERAL CLEANING AND MAINTENANCE
For a constant efficiency of the appliance it is recommended to perform the cleaning and mantainance
operations.
Before to begin with the operations proceed as following:
−
set the general cut-out in OFF position
−
remove the plug from the socket and wait till the complete
entfrosting of the appliance.
Clean the refrigerating group and the finned evaporator, using a vacuum cleaner or a non-metallic brush.
