Electric half-width shut-off
The valve is adjusted with the positioning motors
on the metering unit:
The motor is selected in the terminal by the
half-width shut-off, see E-Manager operating
instructions.
Tram line with half-width shut-off
If a tram line is required with section shut down
enabled, one must consider the installation po-
sition of the valves.
Hoses may need to be replugged or the control
adapted.
Seed flow monitoring with half-width shut-off
If the switched off section is equipped with
sensors for seed flow monitoring, these would
indicate corresponding alarm messages in the
terminal.
You can either switch off seed flow monitoring,
or unplug the sensors and correct their number
in the machine configuration.
Please note: The sensor numbers can also be
entered into the tram line list. In this case this
list would also need to be updated.
¾
Switch off the desired section in the terminal.
Both wings will be adjusted - the display
flashes.
¾
The seed and fertiliser quantity is halved.
¾
For the drilled area counter the working width
is automatically halved.
¾
Once the two valves are in right or left switch-
ing position, the switched off half width disap
-
pears from the display.
NOTE
¾
In spite of the status display on the terminal,
visual inspection is necessary to check wheth-
er the half-width flap is at the correct position.
¾
Check the function of the half-width shut-off
during field use. The positioning motors must
each be in their end position.
Seed flow monitoring is automatically switched off.
34
35
