EN
5
BNF Basic/PNP
Battery Installation and ESC Arming
Battery Selection
We recommend the E-fl ite
®
800mAh 11.1V 3S 30C Li-Po battery
(EFLB8003SJ30). Refer to the
Optional Parts
list for other recommended
batteries. If using a battery other than those listed, the battery should be within
the range of capacity, dimensions and weight of the E-fl ite Li-Po battery packs
to fi t in the fuselage.
1. Lower the throttle to the lowest settings. Select the multirotor fl ight mode.
Power on the transmitter and wait approximately fi ve seconds.
2. Carefully lift the front of the battery hatch and pull forward to remove it.
3. Install the fully charged battery in the battery compartment as shown.
Secure using the hook and loop tape.
4. Connect the battery to the fl ight controller.
5. Keep the aircraft upright, immobile and away from wind or the system may
not initialize.
• The motor nacelles will rotate to the middle position briefl y and then to
the upright, Multirotor fl ight position, indicating the fl ight controller has
initialized and the ESCs are armed.
CAUTION:
Always keep hands away from the propeller. When armed,
the motor will turn the propeller in response to any throttle movement.
6. Reinstall the battery hatch.
7. Refer to the Center of Gravity section to ensure the model balances at the
recommended CG.
Center of Gravity (CG)
The CG location is within 25-30mm,
measured from the the leading edge of
the wing at the root, as shown in the
illustration.
NOTICE:
The main motor nacelles must
be in the Airplane Flight Mode when
checking the center of gravity. Failure
to do so will give an incorrect center of
gravity and may cause a crash. Crash
damage is not covered under warranty.
25-30mm
