EN
8
Cirrus SR22T 1.5m
Model Assembly
A
D
C
M3 x 8mm button head machine
Landing Gear Installation
Main Gear
1. Install the landing gear assemblies
(A)
into the mounting locations on the sides
of the fuselage as shown.
2. Secure the landing gear into place with the four M3 x 8mm screws
(B)
as shown.
Nose Gear
1. Remove the top half of the cowl by pulling straight forward; the cowl is retained
with magnets and aligned with pins.
2. Install the nose gear assembly
(C)
into the pivot block on the bottom of the
firewall as shown.
3. Insert the z-bend pushrod into the outer hole in the steering arm.
4. Use a Phillips screw driver to tighten the M3 x 8mm screw in the nose gear
steering arm
(D)
so it grasps the nose gear strut on the flat spot.
5. Re-install the cowl.
Horizontal Stabilizer Installation
1. Insert the horizontal tail joiner tube
(A)
into the fuselage. Slide the horizontal tail
halves
(B)
into place with the control horn facing down.
2. Use a Phillips screw driver and the included 2 screws
(C)
to secure the
horizontal stabilizer halves in place. Use caution to avoid over-tightening the
screw.
3. Attach the pushrod keeper on the elevator pushrod to the control horn.
A
B
2 x 10mm self-tapping
button head
Pushrod Keeper Installation
1. Insert the end of the pushrod with the 90˚ bend into the control horn and Insert the
pushrod into the hole in the pushrod keeper.
2. Rotate the pushrod keeper and press into place on the pushrod until it clicks into
position.
1
2
B
C
