EN
11
Control Direction Test
Switch on the transmitter and connect the battery. Use the transmitter to operate
the aileron, elevator and rudder controls. View the aircraft from the rear when
checking the control directions.
WARNING:
activate throttle cut from transmitter before powering on the ESC.
Elevator
1. Pull the elevator stick back. The elevator should move up, which will cause the
aircraft to pitch up.
2. Push the elevator stick forward. The elevator should move down, which will
cause the aircraft to pitch down.
Ailerons
1. Move the aileron stick to the left. The left aileron should move up and the right
aileron down, which will cause the aircraft to bank left.
2. Move the aileron stick to the right. The right aileron should move up and the left
aileron down, which will cause the aircraft to bank right.
Rudder
1. Move the rudder stick to the left. The rudder should move to the left, which will
cause the aircraft to yaw left.
2. Move the rudder stick to the right. The rudder should move to the right, which
will cause the aircraft to yaw right.
Flaps
1. Move your flap control switch to the “half flaps” position.
2. Confirm that the flaps move down.
3. Move flap control switch to the full flaps position.
Confirm the flaps move farther down than in step two.
If the control surfaces do not respond as shown,
DO NOT FLY.
Refer to the
Troubleshooting Guide for more information. If you need more assistance, contact
the appropriate Horizon Hobby Product Support department. If the aircraft responds
as shown, continue on to the Flight Control section.
Transmitter
Command
Control Surface
Response
Elev
ator
Aileron
Rudder
Flaps
