Horizon Hobby Cirrus SR22T, Instruction Manual, Page: 10 / 19

EN
10
Cirrus SR22T 1.5m
Scale Accessories Optional
2 x 6mm
self-tapping
button head
Scale accessories are each held in place with a single 2 x 6mm self
tapping screw using a Phillips screw driver.
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
If you adjust the linkage positions for more control throw, then experience control
surface oscillation in flight, return the linkage to its original position.
Horns Arms
Elevator
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
Rudder
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
More control throw Less control throw
Elevator
Flaps
Tail wheel
High Rate Low Rate
Aileron
p =25mm
q = 25mm
p = 15mm
q = 15mm
Elevator
p = 15mm
q = 15mm
p = 11mm
q = 11mm
Rudder
 = 16mm
 = 16mm
 = 10mm
 = 10mm
Flaps
Landing Takeoff
q = 30mm q = 15mm
Flap to Elevator Mix Flap to Elevator Mix
10% down elevator 6% down elevator
Program your transmitter to set the rates and control throws based on your
experience level. These values have been tested and are a good starting point to
achieve a successful first flight.
After flying, you may choose to adjust the values for the desired control response.
Dual Rates and Control Throws