Horizon Fitness PF-P330, Manual

Page: 34 / 70

3-10
3: Adjusting and Checking Procedures
3-9 Feed Rotor Check
Vacuum Pipe
This pipe does not rotate.
Suctions air the holes
at the bottom.
Vacuum Rotor
This ring rotates and suctions
the sheet through the radial slits.
Profile
Setting Block
Vacuum Pipe
Wave Washer
WW-30
Vacuum Rotor
Thrust Ring
Feed Ring
Holes at the
bottom
SB4-20
N4
Grease
does not
come out.
Can be turned
smoothly by hand.
Cutout at the bottom
This parts (front
/rear) are at the
same angle.
Torque
11kg / cm
60 mm
(2.4")
2
6
1
5
3
Thrust Ring Wave Washer
Setting Block
(rear)
WW-30
Shrink
amount = 2 mm
(0.08")
4
Fig.1 Feed Rotor Unit
Fig.2 Feed Roller (front) Fig.3 Wave Washer
PF-P330 has the same feed rotor that is
installed on collating machine VAC-100.
Check
1
The cutouts on both edge of the
vacuum pipe face the bottom. (Fig.2)
2
The setting blocks (front and rear)
faces at same angle and level to each
other. (Fig.2)
3
The edge of the pipe positions 60 mm
(2.4”) ahead from face of the setting
block. (At front and rear) (Fig.2)
4
The shrink amount of the wave washer
is 2 mm (0.08”.) (Fig.3)
[Additional Information]
The stretching force of the washer removes
the gap in the thrust direction.
5
The torque on the setting block is
11kg/cm. (Fig.2)
6
The installed feed rotor rotates
smoothly.