Hoppecke trak HF premium, Operating Manual

Page: 19 / 188

19
3 Technical data
3.1 Electrical data
AC supply voltage
see type plate
3~ 400..480 V/50..60 Hz
AC current consumption
see type plate I
max
5..29.9 A per phase
and depending on design
Nominal DC battery voltage
see type plate 24..80 V
depending on design
DC charge current
see type plate I
max
30..325 A
depending on design
Power supply output P
max
3.3..17.2 kVA
Output factor under normal conditions approx. 0.97
Short-circuit-proof Yes
Reverse polarity protection Yes
Excess temperature protection class 1
Excess voltage category 2
Contingent dimensioning short circuit current I
CC
:1 kA
Minimum required short circuit current I
CP, mr
: 30 A
Degree of disruption 2
An
all-current sensitive version
must be installed when using
residual
current devices (Ia = 30 mA)
.
3.2 Ambient conditions
Place of use
In dry, well-ventilated
areas up to at most
1.000 m above sea level
Ambient storage temperature -25..+60 °C
Ambient temperature for activation 0..+40 °C
Ambient temperature for operation -5..+40 °C
Relative humidity Max. 90 % (at 23 °C)
Dusty environments
Exclusively with a filter
(accessory)
Protection against contact, dust IP 21 and water
3.3 Installation
Position the charger on a firm, level surface. The flow of air through the
openings on the underside of the device to the rear side must not be
obstructed.
When installing the charger, make sure that there is a clearance of at least
5 cm to the left, right, and rear of the device in order to ensure adequate
ventilation.
Always install the device at a higher level than the top edge of the battery.
In dusty environments, the charger must always be mounted on the wall
and a dust filter must be used.
Only suitable for installation on concrete or another non-flammable
surface.
Operation in the packaged state is never permissible. The sole exclusion
is brief commissioning of the device under constant observation by a
qualified person.
3.4 Dimensions and type plate
Small housing:
Medium-sized housing:
Example of type plate affixed on the right