you have a problem
This appliance was inspected thoroughly and was in good
;!
when it was shipped from the factory. If a minor problem develops,
it usually can be remedied quite easily when the cause is identified.
cordingly, this check list is provided for your convenience.
Problem Possible cause
Cleaner 1. Not firmly plugged in.
won’t
2. No voltage in wall plug.
run
3. Blown fuse/tripped
breaker.
Possible solution
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/ reset breaker.
won’t
1.
or worn agitator
.
pick up
2. Agitator brushes worn.
3. Bag full.
4. Obstruction in cleaner.
5. Bag not opening.
Cleaner 1. Power Drive belt broken
won’t
or worn.
drive
2. Manual operation button
pushed down.
1. Replace belt.
2. Replace brushes.
3. Change throw away bag.
4. Clear pivoting dirt duct
and/or dirt tube.
5. Check for firm bag con-
nection.
1. Replace belt.
2. Make sure handle grip
slides freely.
If the problem persists,
check the Yellow Pages of your telephone book
under “Vacuum Cleaners Household” for your nearest
Hoover Factory
Service Center or Authorized Warranty Service Dealer
where approved
HOOVER service and genuine HOOVER replacement parts may be ob-
tained. The warranty provided with this product has a listing of the
Hoover Factory Service Centers. If you are unable to obtain the informa-
tion you need from the Yellow Pages, contact a Hoover Factory Service
Center to find your nearest Authorized Warranty Service Dealer. For
service under warranty, follow the instructions in the Warranty provided
with this product.
Do not
send your cleaner to The Hoover Company in North Canton for
service as this will only result in delay.
Always identify your cleaner by model number when requesting informa-
tion or ordering replacement parts. (The model number appears on the
bottom of the cleaner.
If further assistance is needed, contact
The Hoover Company Con-
sumer Affairs Department, North Canton, Ohio
Lubrication
The motor is equipped with one ball bearing and one needle roller bear-
ing. These bearings contain sufficient lubrication for the life of the motor.
The addition of lubricant could cause damage.
Therefore, do not add
lubricant to either motor bearing.
The agitator is equipped with two ball bearings that should be lubricated
periodically. This should be done by a Hoover Factory Branch Service
Center or an Authorized Hoover Warranty Service Dealer.
22
Summary of Contents for Concept one
Page 1: ......
