Honeywell Vuquest 3310g, User Manual

Page: 64 / 278

3 - 14
Character Activation Laser Timeout
You can set a timeout for the length of time the laser remains on and
attempting to decode bar codes when using Character Activation Mode.
Set the length (in milliseconds) for a timeout by scanning the following bar
code, then setting the timeout (from 1-65535 milliseconds) by scanning dig-
its from the
Programming Chart , then scanning Save . Default = 5000 ms.
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the fol-
lowing
On bar code to use character deactivation, then use Deactivation
Character (following) to select the character you will send from the host to termi-
nate scanning.
Default = Off.
End Character Activation After Good Read
After a bar code is successfully detected and read from the scanner, the
illumination can be programmed either to remain on and scanning, or to
turn off. When
End Character Activation After Good Read is enabled,
the illumination turns off and stops scanning after a good read. If you scan
Do Not End Character Activation After Good Read , the illumination
remains on after a good read. Default = End Character Activation After
Good Read.
Character Activation Laser
Timeout
* Off
On
Do Not End Character Activation
After Good Read