Honeywell ScanPal EDA71, User Manual

Page: 14 / 92

4 EDA71 User Guide
Battery Part Numbers
Charge the Battery Before Use
Before using EDA71, you need to make sure the battery (model number: BAT-
EDA50) is fully charged. You can charge the battery before or after installing it to
EDA71. It will take about
5 hours for the battery to be fully charged using original
charger, quad bay charger, or single cradle charger.
Note: Honeywell recommends recommend using Honeywell’s original charger; any
damage caused by use of non-Honeywell charger is not covered by warranty.
Note: Using the tablet while charging the battery increases the time required to reach a full
charge.
Warning: Improper use of the battery in this device can cause fire or
chemical burns. Please do not disassemble the battery or heat
it to 100°C (212°F) and above, or incinerate the battery. Make
sure waste batteries are properly disposed. Keep out of reach
of children.
Warning: Do not store the battery without using for a long period of time.
If storing the battery for over 3 months, please make sure to
check the remaining battery power capacity is at least 30%
every 3 months.
Warning: Read Battery Recommendations and Safety Protections and all
cautionary markings on the battery, charging peripheral, and
device using the battery before attempting to install, use, or
charge the battery.
Battery Model
Number
Battery Part Numbers
BAT-EDA50 50129589-001
50134176-001 (For use in North America)
EDA70-EXT 50141821-001
Warning: Ensure all components are dry prior to mating the tablets and
batteries with peripheral devices. Mating wet components may
cause damage not covered by the warranty.