Honeywell ScanPal EDA51, User Manual

Page: 50 / 100

40 EDA51 User Guide
3. Center the aiming beam over the barcode. Make sure the entire barcode is
inside of the illumination frame.
4. Release the Scan button when the computer beeps, and the Scan Status LED
briefly turns on. The barcode information is entered into the application in use.
Note:
Not all barcode symbologies are enabled by default. If a barcode does not scan, the
correct symbology may not be enabled.
About Scanning Configuration Barcodes
After completing the out-of-box set up process, Provisioning mode is
automatically turned Off. Scanning a barcode to install applications, certificates,
configuration files, and licenses on the computer is restricted unless you enable
Provisioning mode in the Settings app.
To learn more About Provisioning Mode see page 70 .
Use the Scan Demo App
Use the Scan Demo app to read barcodes, or to test your symbology decode
settings.
1. Swipe up from the bottom of the Home screen to access all apps.
2. Tap Demos .
3. Swipe left or right on the screen until Scan Demo appears under the turntable.
Tap the center of the box image to open the app.
4. Point the scanner window at the barcode.
5. Press and hold any Scan button or tap and hold the on-screen Scan button.
6. Center the aiming beam over the barcode. Make sure the entire barcode is
inside of the illumination frame.