46
The readers are
not responding to
card reads
Option 1:
Be sure that OSDP readers
have been connected or are in OSDP
mode
Option 2:
Set up the correct addressing
on the OSDP readers. Addresses other
than '00', '01' or '02' are not recognized.
Set the reader in one of these
addresses:
'00' for auto addressing
'01' for entry reader
'02' for exit reader
Option 3:
Make sure that the reader
baud rate is set to
9600 Baud
Option 4:
Make sure that the reader
accepts secure channel communication
Problem
Solution
Summary of Contents for MPA1C1
Page 4: ...3 Introduction This document describes how to install the MPA1C1 access control unit ...
Page 8: ...7 MPA1C1 door with single reader and door strike MPA1C1 door with two readers and door strike ...
Page 17: ...16 Note The MPA1C1 Controller has been installed already in the MPA1ENCP enclosure ...