5
MPA1C1 Overview
An MPA1C1 access control unit is a full-featured single-door
web-based smart edge access control system.
The MPA1C1 panel includes a built-in web server, built-in Ether
-
net, and PoE (Power over Ethernet) capability. You can manage
the access control system using either a web browser, MPC
(MAXPRO® Cloud) or WIN-PAK.
For supported configurations, see beginning on page 32 to view
illustrations of the supported MPA1C1 system configurations.
Note:
• The MPA1C1 web server/browser is intended for monitoring and
programming use only.
• MPC and WIN-PAK software are intended for monitoring and
programming use only, and have not been evaluated by UL.
Panel Components and Descriptions
Note:
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
The MPA1C1 panel consists of a web browser enabled control
-
ler, and a PoE power supply. The following figures show the
MPA1C1 panel wiring and components and the typical door
configurations that the panel can be used in.
Summary of Contents for MPA1C1
Page 4: ...3 Introduction This document describes how to install the MPA1C1 access control unit ...
Page 8: ...7 MPA1C1 door with single reader and door strike MPA1C1 door with two readers and door strike ...
Page 17: ...16 Note The MPA1C1 Controller has been installed already in the MPA1ENCP enclosure ...
