LANSRLU1
Honeywell Access Systems
4
7-101002-00
LEDs
The UDS100 device uses LEDs to
indicate the following conditions:
•
10 Mbps Link/Activity (green)
•
100 Mbps Link/Activity (green)
•
Collisions
•
Diagnostics (red)
•
Status (yellow)
Assigning the IP Address
LEDs
Definition
10 Mbps Link/Activity steady (green).
Valid 10 Mbps network connection.
10 Mbps Link/Activity blinking (green).
Network packets transmitting and receiving.
100 Mbps Link/Activity steady (green).
Valiid 100 Mbps network connection.
100 Mbps Link/Activity blinking (green).
Network packets transmitting and receiving.
Collisions blinking red.
Network collisions.
Diagnostics steady red and status
blinking green.
1 blink = EPROM checksum error.
2 blinks = RAM error.
4 blinks = EEPROM checksum error.
5 blinks = Duplicate IP address on networ.k
Diagnostics blinking red and status
blinking green.
4 blinks = Faulty network connection.
5 blinks = No DHCP response.
Status steady green.
Serial port not connected to network.
Status blinking green.
Serial port connected to network.
Method
Description
DeviceInstaller
User manually assigns the IP address using a GUI.
The UDS unit must be attached to the network.
ARP and Telnet
User manually assigns the IP address and other net-
work settings at a command prompt using UNIX ro a
Windows based system. The user must be logged
onto the configuration port (9999).
Serial Port Login
Configure the unit through a serial connection.
Note: The UDS device is shipped with a default IP address of 0.0.0.0.
