Honeywell IQ Force, Reference Manual

Page: 25 / 60

IQ Force™ Dock Reference Manual 17
Initial PC–Dock Connection
Once this is accomplished, set the two parts aside. The section
that will be used is shown in the following images (depending on
the number of docks).
Figure 11. Fresh Air Tubing for two Docks
Figure 12. Fresh Air Tubing for eight Docks
Figure 13. Fresh Air Tubing for four Docks
3. Connect the pieces of tubing above the check valves to filter that
was installed on the dock in step 2.
At this point, the tubing assembly should be connected to each dock’s
AIR port.
4. Connect the only open piece of tubing (below the black T-fittings)
to the demand flow regulator on the gas cylinder or to the conduit
for the external source of fresh air.
2.8 Initial PC–Dock Connection
Once the software has been installed, and the USB wire(s) is/are plugged
into the USB port, the Found New Hardware Wizard screen will be shown
on the PC and a number of messages will be shown on the IQ Force dock.