Document 800-01802 Rev B
9
02/09
Note
To ensure a waterproof installation, the notch in the camera base
that the power and video connections exit through should be facing
down.
If the power and video connections exit the top of the base (wall
mounted only), water may pool in the camera base. To minimize
moisture entering the base, apply appropriate sealant around the
notches and any other gaps between the camera base and the
mounting surface.
Positioning the Camera
Caution
Do not swivel and position the camera without the
mounting bracket firmly in place.
Loosen the thumb screws and move the camera into position. Swivel the
camera to capture the desired field of view. Tighten the thumb screws to set
the position.
Lens Setup
Adjusting the Zoom and Focus of the Lens
The zoom and focus adjustment is located on the underside front end of the
camera housing. Use a flathead screwdriver to adjust the zoom and/or focus.
Figure 2
Lens Controller
Zoom adjustment screw
Turn counter-clockwise for wide angle
Turn clockwise for telephoto
Focus adjustment screw
Turn counter-clockwise for near focus
Turn clockwise for far focus