GSMX Installation and Setup Guide
– 6 –
GSMX-005-V0
PANEL DATA IN - Green
GND - Black
AUX PWR (+12V) - Red
PANEL DATA OUT - Yellow
To ECP Bus on control
panel circuit board.
ECP Cable
Threaded Mount
Control Panel
Cabinet
5.
Refer to the installation guide for the control panel, and complete the
ECP cable wiring.
6.
Secure the wiring with ties as necessary.
Mounting the Module on the Wall
1.
Ensure power to the control panel (both AC and battery) is off, then
remove a suitable knockout on the top or side of the control panel
cabinet.
NOTES:
•
If in the wall wiring will be used, route the wiring through the
communications module's rear wiring access hole.
•
If surface mounted wiring will be used, remove the
communications module's bottom knockout and use that to route
the wiring.
2.
Open the GSMX cover. Remove the Hole Cap attached to the plastic
(trim as necessary), and snap it into the top opening of the enclosure.
3.
Secure the enclosure to the wall using both mounting holes.
Summary of Contents for GSMX
Page 30: ...NOTES ...