Honeywell EQUIP HD4MDIH, User Manual

Page: 21 / 80

HD4MDIH/X EQUIP Series True Day/Night Rugged IP Network Camera User Guide
Document 800-07496 Rev A 21
12/10
Step 3. Preparing the Mounting Surface
1. Affix the mounting template (supplied in the camera box) to the mounting surface or
use the back of the camera base, as shown below, to trace the screw holes.
Figure 2-3 Tracing the Camera Base
Note To prevent moisture from entering the housing, position the enclosure with
the side conduit entry pointing down if you are mounting the camera on a wall
or other vertical surface.
2. Pre-drill three holes as indicated on the template, using the recommended hole size
for the screws being used.
3. Drill out the conduit hole, if required (if you are flush-mounting the camera and pulling
the wires through the back entry conduit) (see Step 4. Installing the Conduit Plug ,
page 21 ).
Note Alternate fasteners (preferably stainless steel) can be used, provided they are
not larger than the screw holes on the mounting template.
Step 4. Installing the Conduit Plug
Your camera enclosure base comes with a conduit plug pre-installed in the 3/4 inch conduit
entry on the back. To use the back conduit entry, remove the conduit plug and install it in
the side conduit entry after loosening the locking screw (see
Figure 2-4
)
. Retighten the
locking screw to secure the conduit plug in place.