Honeywell CDMA-X, Installation And Setup Manual, Page: 20 / 24

CDMA-X Installation and Setup Guide
– 18 –
Status Displays
[E] Service
RSSI 1X/EVDO REG
-xxxdbm stat x
Status Display Screen 1
RSSI – RSSI level in dBm.
Communicator is on 1X/EVDO network where “stat” can be:
Good RSSI –20 to –90 dBm
OK RSSI –91 to –100 dBm
Marginal RSSI –101 to –106 dBm
Bad RSSI –107 to –150 dBm
REG – Registration status where “x” can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the last screen.
RAN Ec/I0 (dBm)
1X -xxx
Status Display Screen 2
RAN – Radio Access Network. (1X or IS-95A)
Ec/I0 – Ratio of channel power to traffic power; roughly equivalent to noise ratio. A
number closer to zero is better.
Very Good Good Fair
0 -1 -2 -3 -4 -5 -6 -7 -8 -9 -10 -11
Poor High Noise
-11 -12 -13 -14 -15 -16 -17 -17 -19 -20
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
SID NID
xxxx xxxxx
Status Display Screen 3
SID – System Identification, identifies the cell network in the local area.
NID – Network Identification, identifies the overall network.
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Cell Channel
N/A xxx
Status Display Screen 4
Cell – Base Station ID
Channel – Control Channel in use.
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.