Honeywell Ademco VISTA-50P, Installation And Setup Manual

Page: 33 / 112

Section 3 - Installing the Control
3-21
The 4285/4286 VIP Module features:
•
Allows the user to receive synthesized voice
messages over the phone regarding the status of
the security system.
•
Allows the user to arm and disarm the security
system and perform most other commands using
the telephone keypad.
•
Allows the user to control relays using the
telephone keypad.
•
Provides voice annunciation over the phone to
confirm any command that is entered.
•
Announces many of the same words that would
normally be displayed on an alpha keypad under
the same system conditions. Refer to the words in
bold on the Alpha Vocabulary list found in the
#93
Menu Mode in the Programming Guide .
•
Can be supervised for connection to control panel
(annunciated and reported as Zone 87).
The 4285/4286 is wired between the control panel and
the premises’ handset(s) (see
Figure 3-26 ). It listens for
TouchTones on the phone line and reports them to the
control panel. During on-premises phone access, it
powers the premises phones. During off-premises phone
access, it seizes the line from the premises phones and
any answering machines.
•
The VIP module will not operate until the
device address (04) is enabled in the control’s
Device Programming in #93 Menu Mode .
•
Do not mount the VIP Module on the cabinet
door or attempt to attach it to the PC board.
To install the VIP module, perform the following steps:
Step Action
1 Mount the module in the control cabinet if
space is available or, if this is not possible, on
the side of the cabinet or adjacent to it.
If you mount the VIP Module inside the
control cabinet,
attach it to the cabinet’s
interior surface with 2-faced adhesive tape.
You may leave the module’s cover off if it is
mounted within the cabinet.
If you mount the module outside the
cabinet,
use the screw holes at the rear to
mount horizontally or vertically (2-faced
adhesive tape may be used, if preferred).
2 Affix the 4285/4286 connections label
(supplied separately) to the inside of the VIP
Module’s cover, if the cover is used.
Otherwise, affix the label to the inside of the
control cabinet’s door.
Step Action
3 Make 12V (+) and (–) and data-in and data-
out connections from the VIP Module to the
control, using the connector cable supplied
with the VIP Module. These are the same
connections as for remote keypads.
Connect the module to the phone line as
shown below. See
Figure 3-26.
4285/4286 Terminal Connects to direct
connect cord:
1. Phone In (Tip) green wire
2. Phone In (Ring) red wire
3. Phone Out (Tip) brown wire
4. Phone Out (Ring) gray wire
5. No Connection
6. Audio Out 1
∗
Speaker
7. Audio Out 1
∗
Speaker
Supported by the 4286 only
4
Use an RJ31X Jack with the phone cable
supplied with the control to make connections
to the VIP module. Make connections exactly
as shown in
Figure 3-26 . This is essential,
even if the system is not connected to a
central station. The 4285/4286 will not
function if this is not done.
•
If touch-tones are not present following phone
access to the security system via an on-
premises phone , try reversing the pair of
wires connected to terminals 3 and 4 on the
4285/4286.
•
If the phone plug is disconnected from the
control, the premise’s phones will not operate.
WWW.DIYALARMFORUM.COM