Honeywell ACUIX ES, Installation And Configuration Manual

Page: 49 / 86

ACUIX TM ES Installation and Configuration Guide
Document 800-01949 Rev D 49
05/09
Note For Pelco P_AD and Pelco D_AD switch settings and special presets, see
Appendix A.
Table 3-2 Special Presets Based on Protocol
Preset Function Protocol Cross Reference
72 Recover encrypted user login PIN and GUID All page 75
73 Enable broadcast command receive mode MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P page 76
74 Disable broadcast command receive mode MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P page 76
75 Administrator / password/PIN settings
• 1. User Login PIN
• 2. Change PIN
• 5. System Info
• 6. Change Address, Protocol
All System Administration
and Settings
, page 71
80, 81,
82 Run mimic tours 1, 2 and 3 MAXPRO-mode, VCL,
VCL UTC, Pelco D and P page 60
83, 84,
85 Program mimic tours 1, 2 and 3 MAXPRO-mode, VCL,
VCL UTC, Pelco D and P page 60
86 Stop or end mimic tour programming
sequence MAXPRO-mode, VCL,
VCL UTC, Pelco D and P page 60
87, 88,
89 Start/run preset tours 1, 2 and 3 MAXPRO-mode, VCL,
VCL UTC, Pelco D and P page 61
90 Setup menu (on-screen display/OSD) MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P Step 4: Open the OSD
Menu and Start
Configuring
, page 50
91, 97
and 99
94 and
95
Reserved
Reserved and not available with the Sony
FCB EX-45C camera
MAXPRO-mode, VCL,
VCL UTC, Diamond,
Pelco D and P n/a
92 Toggles auto exposure or iris ON and OFF
(factory default is ON) MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P page 57
93 Toggles backlight compensation ON and
OFF (preset 92 /auto exposure must be ON) MAXPRO-mode, VCL,
VCL UTC, Diamond and
Pelco D and P page 57
96 Run the Flashback function MAXPRO-mode, VCL,
VCL UTC, Pelco D and P page 50
98 Camera lens reset or cycles the power
(camera dependent) All page 72