2
SETUP
STEP 1. OPEN SAFE DOOR
All new safes are shipped with the door unlocked. If the door has become locked during
shipping, open it with the override key as follows:
USING THE OVERRIDE KEY:
1.
Remove Override key cover.
2.
Insert override key and turn left to unlock safe.
3.
Lift Lever towards you
4.
Lift Safe door upwards until it locks in place
STEP 2. INSTALL BATTERIES
1.
Remove battery cover on inside door.
2.
Insert 4 “AA” batteries (included).
3.
Replace the battery cover.
4.
Do not close door before testing digital lock.
5.
Insert batteries in the correct direction (See diagram)
STEP 3. TEST DIGITAL LOCK
1.
With door open, make sure lever is in the locked position.
2.
Enter the preset pass code: “1”-“5”–“9”-“B”.
3.
Lift lever within 5 seconds.
4.
Lock bolts should recede into the unlocked position.
STEP 4. PROGRAM A NEW PASSCODE
1.
With door open, press reset button inside door.
2.
Ready light flashes along with a beep.
3.
Enter new code (3 to 8 digits) followed by “A” or “B”.
4.
Safe will beep and ready light will turn off.
NOTE: The factory pre-set code will not work after a new pass code is programmed.
OPERATION
TO OPEN THE SAFE
1.
Make sure lever is fully in the closed position
2.
Enter your new code followed by “A” OR “B”.
3.
Pull lever towards you and lift door open fully
TO CLOSE THE SAFE
1.
Lower door by lever into closed position.
2.
Turn door entry knob to left to engage the lock
bolts and lock safe.
NOTE: Safe will not operate if lever is not fully in the locked position.
3
SECURE LOCKOUT PERIODS
If a wrong code is entered three times in a row, the digital keypad will begin a five-minute
secure lockout period. During this secure lockout period the keypad will become disabled.
Once the lockout period has expired, the safe can be unlocked using the correct pass code.
You may use the override key to open safe, but keypad will complete the full lockout period.
OVERRIDE ACCESS KEY
If the pass code is unavailable or your keypad fails due to dead batteries or other malfunction,
you can open the safe using the override access key (see STEP 1. in the SETUP section).
REPLACING BATTERIES
Note: The pass code will not be erased if the batteries become weak or are removed.
To replace the batteries please follow the instructions in STEP 2. in the SETUP section. If your
batteries are completely dead and you cannot open the safe by using the digital keypad, use
the override access key to open safe and access the battery compartment.
NOTE: It is NOT RECOMMENDED to use Non-alkaline or rechargeable batteries. Weak or dead
batteries should be removed promptly. Also remove batteries if the safe will not be in use for an
extended period of time.
IF YOU FORGET THE PASSCODE
1.
Use the override access key to open safe. Refer to STEP 1 in the SETUP section.
2.
Program a new pass code. Refer to STEP 4 in the SETUP section.
LOCATING SAFE IDENTIFICATION NUMBERS
SERIAL NUMBER
Located on lower right corner on front of safe.
Do Not Remove Safe I.D. Tags!
KEY NUMBER
4 Digit Number etched on the metal collar located around
the key hole.