Administrating the Device
34
Maximum Exposure Time:
Set the Maximum Exposure Time. However, the real exposure time may be shorter if good
light condition.
Power Frequency:
Frequency of power line: 50 or 60Hz.
50Hz: Local Video out is PAL.
60Hz: Local Video out is NTSC.
Exposure Value:
Exposure value is AE target value. This value is to adjust the integration, analog gain and
digital gain to achieve the target brightness value (Exposure Value).
This value is dependent to “Auto Exposure” only.
Color Level:
Large value will be colorful.
Hue:
Change the value will result to color tuning.
Brightness:
Large value will brighten camera.
Contrast:
Large value will contrast camera heavily.
Sharpness:
Large value will sharpen camera.
Local video output:
Enable or disable video signal of BNC to a TV monitor. It’s very useful to check view angle
or focus during camera installation. However, disable this function will save power a lot.
Suggest to disable it after camera installed.
ICR:
Use built-in photo sensor or manual to control ICR.
In case user selects manual mode, there are 4 modes: Night (On), Day (Off), Auto or
Schedule to control built-in IR LEDs. This function is very useful under low illumination
environment even 0 Lux.
In case the Auto mode is selected, user needs to specify 3 parameters in advance:
Night Mode Threshold (0~10000): this value set the threshold to turn on IR LED. It should
be lower or equal to Day Mode Threshold.
