Honeywell 15.112.771 User Instruction Manual Download Page 12

Page: 12 / 96

• measure the textile in tension (see table below)

Manyard

Type

Ref

L Max

2 M

1005318 - 1005325

1005327 - 1006709

1009770 - 1009771

1009772 - 1009773

1009774 - 1013491

1013520 - 1014690

1014938

1 m 68 cm

1,75 M

1010470

1 m 46 cm

1,5 M

1005317 - 1005324

1011754 - 1013521

1003970 - 1014659

1 m 21 cm

In case of doubt, the lanyard should not be used, since the energy absorber was not designed to

stop more than one fall.

CLEARANCE

If there is a risk of falling or if the harness can only be anchored below the hook point, a lanyard

with an energy absorber must absolutely be used. Check before using an energy absorbing lanyard

and manyard that there is enough clearance under the user’s feet to avoid any collision with the

structure or the ground. With a mass of 100 kg and a fall factor situation of two (most unfavoura-

ble), the headroom D is the stop distance H (2L + 1.75 m) plus a supplementary distance of 1 m,

with length L (l energy absorber) Ex. For a lanyard with energy absorber where L=2 m, the

minimum clearance D=6.75 m.

PERIODIC INSPECTION

These instructions must be kept with the product. Use the identification card for recording the la-

belling information. The periodic inspection shall check the equipment’s effectiveness and

strength and is essential to guarantee the user’s safety.
This equipment must be examined, at least once a year, by a competent person and

in strict compliance with the manufacturer, the verification to be recorded on the

attached sheet and by affixing a self-adhesive dot on the product (see fig. 1) .The

legibility of the product labelling must be checked.

LIFESPAN OF THE PPE

The maximal life of PPE that is predominantly textile is evaluated as being 10 years after the date

of manufacture, however, the following factors may reduce the performance of the product and the

lifespan: incorrect storage, incorrect use, fall arrest, mechanical warping, contact with chemicals

(acids and alkalis), exposure to high temperatures > 60°C.

ANCHORAGE POINT

If possible, to be used with anchorage devices (conformed to the EN 795 standard) or structural

anchor. that is to say elements fixed to last, to a structure (wall, post…).
In all cases, check that the anchoring point:

• Has a minimum resistance of 12 kN,
• Is located above the operator,
• Is located within a vertical axis of the work area (maximum angle ±30°),
• Adapts perfectly to the equipment’s attachment device,
• Has no sharp edges.

MAINTENANCE AND STORAGE

Good maintenance and appropriate storage of your PPE will prolong the life of your product, while

guaranteeing your safety. The following recommendations must be strictly respected:

• The product should be cleaned with water and a mild soap. Never use acidic or basic solvents.
• Allow it to air dry in a well ventilated area, away from sources of heat. Store the harness away

from humidity and ultraviolet light.

L > L Max.

Fig. 1