22
Installation with Wall Mount Bracket
c
Make a hole whose diameter is 30-40 mm on the
mounting surface. Then prepare the wall mount
bracket. Pull the main cable for the system as
below. Attach the wall mount bracket to the
mounting surface. (Hex Lag #14
×
50)
d
Pull the main cable for the system as below. Turn
the bracket adapter on its axis in a clockwise
direction until it stops and then attach the surface
mount bracket. (Machine M3
×
8)
e
Connect the main cable to the ports and install the
main body. (Machine M3
×
8)
f
Align the dome cover stud with the stud on the main
body and slightly push the dome cover. Turn the
dome cover clockwise and install the dome cover
lock-up screw. Then remove the protective vinyl
from the dome cover. (Machine M3
×
6)
Important Notice
z
Before starting the installation, make sure that the camera ID and protocol are set up properly.
z
When the wiring access hole on the side of the surface mount bracket is not used, make sure that the hole is
properly sealed with the supplied rubber gasket.
Bracket Adapter
Surface Mount
Bracket
Installation
