6 of 12
AII 47345 (1209)
© 2012 American Honda Motor Co., Inc. – All Rights Reserved.
12. Attach pieces of electrical tape to the antenna cord
at the measurements shown (points A and B).
13. Using scissors, cut one EPT sealer in half. Wrap one
half of the EPT sealer around the antenna cord at the
measurement shown.
14. Using isopropyl alcohol on a shop towel, thoroughly
clean the inside upper corner of the windshield
where the antenna will attach.
15. Remove four adhesive backings from the antenna,
and attach the antenna to the windshield as shown.
Firmly press the antenna against the windshield to
ensure good adhesion.
862014BY
ANTENNA
CORD
EPT SEALER
Cut in half.
200 mm
130 mm
ELECTRICAL
TAPE
30 mm
A
B
10 mm
40 mm
4 ADHESIVE
BACKINGS
BLACK
CERAMIC
AREA
WINDSHIELD
ANTENNA
ANTENNA
INSIDE
16. Using isopropyl alcohol on a shop towel, thoroughly
clean the outside of the windshield where the cover
seal will attach. Remove the adhesive backing from
the cover seal, and attach the cover seal to the
windshield as shown.
17. Inside the vehicle, carefully insert the antenna cord
between the vehicle panel and the headliner. Be
careful not to crease the headliner.
862016CY
COVER
SEAL
13 mm
37 mm
ADHESIVE
BACKING
OUTSIDE
COVER SEAL
BLACK CERAMIC
AREA
WINDSHIELD
862017AY
ANTENNA
CORD
HEADLINER
VEHICLE
PANEL
