© 2012 American Honda Motor Co., Inc. – All Rights Reserved.
AII 47345 (1209)
11 of 12
42. Secure the XM tuner to the vehicle panel with one
6 mm washer-nut and one 6 x 16 mm washer-bolt.
43. Tighten the blower motor nut installed in step 36.
44. Plug the bus cable 14-pin connector and the antenna
cord 1-pin connector into the XM tuner.
862310CY
XM TUNER
BRACKET B
6 x 16 mm
WASHER-BOLT
XM TUNER
GLOVE BOX
OPENING
6 mm
WASHER-
NUT
BLOWER MOTOR NUT
Tighten.
VEHICLE
PANEL
862312BY
BUS CABLE
14-PIN
CONNECTOR
ANTENNA CORD
1-PIN CONNECTOR
XM TUNER
GLOVE BOX
OPENING
45. If necessary, reposition the excess antenna cord,
and tighten the wire tie loosely installed in step 23.
46. Secure the antenna cord and the bus cable to the
vehicle harness with two wire ties. Do not bend the
antenna cord more than 30 mm.
If the vehicle is equipped with an additional accessory
14-pin connector, continue with step 47; otherwise, go to
step 48.
47. Plug the bus cable 14-pin connector and the other
14-pin connector into the bus cable 2-port 14-pin
connector. Wrap an EPT sealer around each 14-pin
connector.
862313BY
ANTENNA CORD
Bundle the excess.
WIRE
TIE
VEHICLE
HARNESS
WIRE
TIE
BUS
CABLE
30 mm
ANTENNA CORD
Do not fully bend.
WIRE TIE
(installed
in step 23)
862314CY
BUS CABLE
2-PORT
CENTER
PANEL
OPENING
BUS CABLE
14-PIN CONNECTOR
VEHICLE 14-PIN CONNECTOR OR OTHER
ACCESSORY 14-PIN CONNECTOR
EPT
SEALER
Wrap.
