Honda WT30XK4, Manual

Page: 50 / 124

FUEL SYSTEM
6-7
CARBURETOR DISASSEMBLY/ASSEMBLY
Tampering is a violation of Federal and California law.
Remove the carburetor (page 6-6).
Before disassembly, clean the outside of the carburetor.
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
To prevent serious eye injury, always wear safety
goggles or other eye protection when using
compressed air.
ASSEMBLY:
Before installing, clean
thoroughly with a jet
cleaning tool, carburetor
cleaner, and low-
pressure compressed air.
SET COLLAR
SEDIMENT CUP
PILOT JET SET
DRAIN SCREW
SET SCREW GASKET
O-RING
MAIN NOZZLE
MAIN JET
FLOAT PIN
ASSEMBLY:
Before installing, clean
thoroughly with a jet
cleaning tool, carburetor
cleaner, and low-pressure
compressed air.
Lightly lubricate the O-ring
to ensure easy installation
into the carburetor body.
ASSEMBLY:
Before installing, clean thoroughly
with a jet cleaning tool, carburetor
cleaner, and low compressed air.
FLOAT CHAMBER
O-RING
O-RING
SPRING PIN (2 x 12 mm)
CHOKE LEVER
FUEL VALVE PACKING
FUEL COCK LEVER
VALVE LEVER SPRING
LEVER SETTING PLATE
SCREW(3 x 6 mm) (2)
ASSEMBLY:
Install the float chamber to the
carburetor body at an angle as shown.
DRAIN SCREW GASKET
SET SCREW
UPPER SIDE
UPPER SIDE
O-RING
CUP FILTER
FLOAT VALVE SPRING
PILOT SCREW
THROTTLE STOP SCREW
FLOAT
FLOAT VALVE
LIMITER CAP
20°
3.9 N·m (0.4 kgf·m, 35 lbf·in)
NOTE 1:
NOTE 2:
NOTE 3:
NOTE 1 IDLE SPEED ADJUSTMENT page 3-9
NOTE 2 PILOT SCREW REPLACEMENT page 6-9
NOTE 3 CUP FILTER REMOVAL/INSTALLATION page 3-6
61YG1000.book 7 ページ ２０１２年２月２０日 月曜日 午後２時４３分