Honda WT30XK4, Manual

Page: 112 / 124

CRANKCASE
13-17
CRANKSHAFT BEARING
(WT30XK4: 6206)
(WT40XK3: 6207)
Drive out the radial ball bearing (1).
Apply oil to the circumference of a new bearing.
Drive the radial ball bearing until it is fully seated on the
end using the special tools.
CRANKSHAFT OIL SEAL
(WT30XK4: 30 x 45 x 8 mm)
(WT40XK3: 35 x 52 x 8 mm)
Remove the oil seal from the crankcase cover.
Apply grease to the lip of a new oil seal (1).
Drive the oil seal in the position as shown using the
special tools.
WT30XK4 (6206):
TOOLS:
Attachment, 62 x 64 mm (2)
07947-6340400
Pilot, 30 mm (3) 07746-0040700
Driver (4) 07749-0010000
WT40XK3 (6207):
TOOLS:
Attachment, 72 x 75 mm (2)
07746-0010600
Pilot, 35 mm (3) 07746-0040800
Driver (4) 07749-0010000
(3)
(4)
(2)
(1)
WT30XK4 (30 x 45 x 8 mm):
TOOLS:
Attachment, 45 x 50 mm (2)
07946-6920100
Driver (3) 07749-0010000
WT40XK3 (35 x 52 x 8 mm):
TOOLS:
Attachment, 52 x 55 mm (2)
07746-0010400
Driver (3) 07749-0010000
(2)
WT30XK4:
6 mm (0.2 in)
WT40XK3:
2 mm (0.08 in)
(3)
(1)
OIL SEAL RIP
61YG1000.book 17 ページ ２０１２年２月２０日 月曜日 午後２時４３分