SET-UP
AND ASSEMBLY
MOUNTING MOWER
LIFT
SYSTEM
Install with the tractor on level ground.
Lock the parking brake, set the transmission lever
in
(Neutral) and the
clutch lever in the
"OFF" position. Set
Control lever to
"DOWN"
and turn Lowering Speed Control knob fully
("FAST"). This allows you to pull
the rear lift arms down by hand and makes assem-
bly easier.
1.
2.
Installing Mower Lift Plate to Tractor
Remove drawbar assembly; this is bolted onto
the transmission housing below the Rear PTO.
Retain bolts, nuts and spacers for installation of
lift
plate assembly. Remove any dirt and debris
from bottom of transmission housing and make
sure bolt holes and screw threads are clean.
Assemble
Y-lift
bracket to lift plate assembly.
Raised flange on lift plate assembly will face rear
of tractor. Insert
Y-lift
bracket
so that fork
of
Y
faces front of tractor.
3.
Attach mower lift plate assembly to tractor,
passing the two projecting stud bolts on the
transmission housing through the holes in the lift
plate flange. Slide on
2
spacers previously
removed and hand tighten both
26
mm flange
locknuts.
4.
Reach beneath the mower lift plate assembly
and carefully insert the four
12
mm
x
32
mm
bolts through holes in lift plate assembly and
into threaded holes on bottom of transmission
housing. Housing
is
made of aluminum,
so
start
bolts by hand to guard against cross threading.
Tighten to 7 kg-m
(50
ft-lb).
5.
Finish by tightening two
26
mm flange locknuts
on projecting studs to 7 kg-m
(50
ft-lb).
Wear heavy gloves to protect
your hands when installing lift link kit and
mower deck.
Lifting system can crush fingers
and hands,
so
keep them clear of links and
lift
arms when operating.
Mower Lift
Plate
11