The lap/shoulder belts work the same as the two front seat belts.
Make sure both rear shoulder belts are positioned in front of the rear
seat-backs whenever the seat-backs are in their upright positions.
To use the center lap belt, push the tongue plate into the buckle until
it clicks locked. Position the belt across your lap, not your abdomen
and as low on your hips as possible. Pull the loose end of the belt to
adjust for a snug but comfortable fit.
A slack belt will greatly reduce the protection afforded to the wearer.
Hold the tongue plate perpendicular to the belt as shown.
To shorten, pull the end of the belt away from the tongue plate.
To lengthen, pull the tongue plate.
NOTE: When the center lap belt is not in use, store it in the buckle
locators.
Fasten Seat Belt Warning Light and Warning Beeper
Both the light in the
instrument panel and the warning
beeper will go on for about six seconds
when the ignition switch is turned on
and the driver's belt is not fastened.
The beeper will not go on if the
driver's seat belt is fastened before
the ignition switch is turned on, but
the warning light will come on for
about six seconds each time, to
remind the driver to have passengers put their seat belts on. If the
light and beeper do not work as described, have your dealer check the
system.
BUCKLE
TONGUE PLATE
To shorten
To lengthen
Summary of Contents for 1991 Accord Wagon
Page 90: ...Maintenance Schedule cont d...
Page 131: ...page 105...
