13
14
Valve
Remote control
Expansion screw
Remote control holder
Turn on the valve
Before turning on the power,valve
must be turned on for water supply
to the unit.
CAUTION
When power is turned on,unit self-check system will be activated.
You will hear an alarm under water supply failure. The
following steps should be taken then:
Turn off the power-- turn on the valve---power on again.
1.Use an electric drill to drill a small hole in a
suitable position on the wall.
2.Fix the remote control holder on the wall with
expansion screws.
3.Install the remote control on the holder.
The size of the expansion screw and the size
of the drill bit are subject to actual
measurement.
Power supply
1.Install the 120V (greater than 15A) socket at a
position above 23.5"(60cm) from the ground.
2.The socket should be installed in a place
where water is not easy to splash.
3.Use a grounded socket.
4.Insert the leakage protection
plug of the product into
the socket.
WARNING
Please connect the power according to the
power supply requirements of the product,
otherwise it may cause product failure;
the plug should be connected to an
effectively grounded socket,Otherwise, in
the case of power failure or leakage,
it may cause electric shock.
How to install the remote control
HOW TO INSTALL
HOW TO INSTALL
USER MANUAL
USER MANUAL
Power and water supply
Installation diagram
Water supply
Waterproof 10A socket with
ground fault circuit breaker
The installation location of water
and electricity should be set
separately
Wall
T-valve Valve
T-valve
It is recommended to
be larger than 23.5"(60cm)
The water supply source is transferred through the T-valve, one end is connected to the
ceramic water tank to enter the water,the other end is connected to the water supply hose
,
and finally the water supply hose outlet is connected to the adapter of the unit.
1.Applicable water pressure range is
10.87~108.7psi(0.075Mpa-0.75Mpa);
2.Applicable water temperature range
is 41-95
℉
(5~35
℃
)
;
3. Water supply hose length 23.5"(60cm);
Valve should be close to the installation
and disassembly position of this product.
4. Use the new hose set included with this
equipment.
Do not reuse an old hose set.
Main unit
Adapters
Connect to water tank
WARNING
Connect main unit
Valve (shut-off/turn-on)
