USER'S MANUAL
Confirmation and trial operation
1.Check power
3.Check rear wash
4.Check front wash
2.Occupied sensor
Confirm that the leakage protection plug is
plugged in tightly. The LED lits up that the
system has been powered on. If the LED is
not on, you can press the Reset button on
the plug to power on.
After power on, you can hear a beep sound
from the system.
The area shown in the figure is the occupied
sensor. Only when the system senses that the
human body is in the sitting state, the system
function start.
Occupied sensor
Press the rear wash button on the side button
to activate the rear wash function.
(need to maintain the seated state)
Press the front wash button on the side button
to activate the front wash function.
(need to maintain the seated state)
REAR WASH
FRONT WASH
Side button function description
Side LED
Remote control pairing
When the seat senses that the human body is seated, press the rear wash button in the
stop or other mode, the buzzer sounds, the rear wash function is turned on, and it ends
automatically after 3 minutes.
During the cleaning process, press this key again to start or stop the move cleaning
function.If the human body leaves the seat after the function is activated, exit the function.
When the seat senses that the human body is seated, press the front wash button in the
stop or other mode, the buzzer sounds,the feminine cleaning function is turned on, and it
ends automatically after 3 minutes.
During the cleaning process, press this key again to start or stop the move cleaning
function.If the human body leaves the seat after the function is activated, exit the function.
Blue:
Green:
Off:
Green becomes dim:
NON-ECO
ECO
NON-ECO, leaving the seat for a long time
ECO, leaving the seat for a long time
3
2
1
1.Within 15 seconds of powering on the smart toilet cover, press and hold
the stop and seat temperature buttons at the same time
；
2.After the indicator light 3 flashes 3 times, release both buttons at the same time
；
3.Press the stop button to exit the pairing mode and complete the pairing
；
4.If the pairing is not successful, please repeat the above steps.
Indicator status
15
16
CONFIRMATION AND
TRIAL OPERATION
USER MANUAL
USER MANUAL
HOW TO OPERATE
