1
10
Procedure:
Place a 40mm obstacle (1) laid flat on the floor under the garage door. Operate the door in the
down
direction. The door
must
reverse on the obstruction. If the door
stops
on the obstruction, it is not traveling far
enough in the
down
direction. Move Close Limit closer to door
When the door reverses on the 40mm obstacle, remove the obstruction and run the opener through a complete
travel cycle. Door
must not
reverse in closed position. If it does, adjust limit and repeat safety reverse test.
KEEP THESE INSTRUCTIONS
20
The safety reverse system test is important. Garage door must reverse on contact with a 40mm
obstacle laid flat on the floor. Failure to properly adjust opener may result in serious personal
injury from a closing garage door. Repeat test once a month and adjust as needed.
TEST THE SAFETY REVERSE SYSTEM
4. grey
3. white
white wires
twisted together
white/black
wires twisted
together
1
40mm
1
40mm
grey
white
white/black
wires twisted
together
Connecting the Protector System
Locate the terminals on the front of the opener. Strip all
wires back about 10mm then twist the two white wires
and the two white/black wires together. Trim the twisted
wires to approximately 6mm. Use a small screwdriver or
pen to hold down the spring terminals, insert the
white/black wires into the grey terminal (4), then termi-
nate the white (only) wires into the white terminal (3).
INSTALL THE PROTECTOR SYSTEM™
(See accessories)
Note: The opener will automatically detect the Protector System
TM
when it is installed and operating for 5
minutes (during this time the beams must remain unobstructed). The opener will not close unless the
beams are aligned.
SAFETY FIRST!
Whilst Chamberlain have engineered safety features into
your garage door opener, we urge you to consider fitting
IR Beams to your new garage door opener. In many
countries these devices are compulsory to prevent seri-
ous injury or property damage. For your own peace of
mind and the safety of others please install this inexpen-
sive safety device.
Install this accessory for all installations on canopy
doors, one-piece door with horizontal and vertical
track, doors over 2.5m and when the closing force as
measured on the bottom of the door is over 400N
(40kg).
After opener has been installed and adjusted,
The
Protector System™
accessory can be installed.
Instructions are included with this accessory.
The Protector System™ provides an additional
measure of safety against a small child being caught
under a garage door.
It uses an invisible beam which,
when broken by an obstruction, causes a closing door to
open and prevents an open door from closing and is
strongly recommended for homeowners with young
children.
21
Summary of Contents for HE60ANZ
Page 2: ......
