54
Start-up
7.5
Mounting and installation
Please read this entire section before starting to
install the device.
Before installation, please note the device num-
ber (SGTIN) labelled on the device as well as the
exact application purpose in order to make later
allocation easier. You can also find the device
number on the QR code sticker supplied.
To install the Wired Access Point on a DIN rail within a
distribution board, please proceed as follows:
• Disconnect the power distribution panel and
cover any live parts, if required (see hazard infor-
mation).
• Remove the cover of the power distribution panel.
• Place the Wired Access Point onto the DIN rail
(
see fig. 3
). Make sure that you can read the letters
on the device and display and that the connect-
ing terminals for supply voltage
(B)
are at the top.
• During installation, make sure that the locating
springs engage properly and that the device is
securely seated on the rail.
• Plug-in the network cable into the Ethernet con-
necting socket
(F)
and connect it to your router.
• Connect a previously installed 24 V power sup-
ply unit via the input for supply voltage
(B)
to the
Wired Access Point, observing the correct polarity.
Summary of Contents for HmIPW-DRAP
Page 3: ...1 A I E H C D B V HmIPW DRAP V F G J ...
Page 4: ...2 24 V GND BUS 1 BUS 2 HmIPW DRAP ...
Page 5: ...3 4 ...
Page 6: ...6 7 5 ...