61
Start-up
once for channel 1, press twice for channel 2, etc.
The respective channel is shown in the display
(B)
.
• Press and hold down the system button
(A)
for
4 seconds until the LED quickly starts flashing
orange (
see fig. 10).
The pairing mode of the se-
lected channel remains activated for 3 minutes.
• Press and hold down the system button of the
wall thermostat for at least 4 seconds to activate
the pairing mode. The device LED flashes orange.
The device LED
(A)
lights up green to indicate that pairing
has been successful.
If pairing failed, the device LED lights up red. Please try
again.
6.5.2 Adding a new floor heating controller
To add a new floor heating controller to the system or to
the existing devices, please proceed as follows:
• First pair the new floor heating controller with
an existing one. Activate the pairing mode of the
existing floor heating controller. Therefore, press
and hold down the system button
(A)
for at least
4 seconds
(see figure 10)
.
• Activate the pairing mode of the new floor heating
controller. Press and hold down the system but-
ton
(A)
for at least 4 seconds.
