What is the recommended battery type?
Your units will come with 4 “AA” alkaline batteries (2 “AA” batteries required
for each unit). We recommend using only alkaline batteries for replacements.
Where can I mount the remote sensor?
To get accurate readings and to prolong the life of your sensor, we
recommend that you mount it out of direct sunlight and rain. Fog and mist
will not affect the sensor, but large volumes of soaking rain may. To guard
against this, we recommend that you mount it under the eve of your house,
your garage or any other suitable place that will keep it out of direct sun and
rain.
SPECIFICATIONS
Range of temperature/humidity measurement:
Indoor temp :
+23 F to +122 F (-5 C to + 50 C)
Indoor humidity:
25% to 99% RH
Remote sensor:
-4 F to +140 F (-20 C to +60 C)
Channel:
max. 3 remote sensors
Transmission:
max. 100 ft. (30 m) open area, RF434 MHz
Resolution:
0.1 degree for temperature, 1% RH
Clock:
Quartz pre/- 30 sec/month
Batteries:
AA x 2 pcs for main unit, AA x 2 pcs for remote sensor
Battery Life:
12 months (approx.) Alkaline batteries recommended.
8
9
Modifications not authorized by the manufacturer may void users authority to
operate this device.
Note: This equipment has been tested and found to comply within the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
DWS-210-IB SP\ENG 3/25/05 9:15 AM Page 9
