BEFORE YOU BEGIN:
1.
IMPORTANT:
Insert batteries into the home receiver unit first, then the
remote sensor.
2. Place the home unit as close as possible to the remote unit. This will
help with synchronization between the remote sensor and the home unit.
3.
REMEMBER:
Once you are ready to position your remote sensor and
home unit, ensure that the distance is not outside the effective
transmission range (100 feet). Some building materials and location of
the home unit or remote sensor can affect transmission quality and range.
Try various locations for best results.
BATTERY INSTALLATION
Home Receiver:
Lift off the battery cover on the back of the unit. Install 2 “AA” alkaline
batteries included according to the polarity indicated. Close the battery
cover.
Remote Sensor:
Remove the attached bracket stand. Loosen the 2 screws securing the
battery cover with a small screwdriver and remove. Insert 2 “AA” alkaline
batteries included according to the polarity direction indicated. Depress the
C/F button to select either Centigrade or Fahrenheit temperature reading.
Select the channel of the remote sensor by pushing “CH” push button.
Always set the first sensor to channel 1, the 2nd to channel 2 and the 3rd to
channel 3. Ensure the black gasket is properly seated in the housing and
then replace the cover. Tighten the 2 screws to secure.
NOTE: There are no consumer serviceable parts.
(See Warranty section for contact information.)
GETTING STARTED
SETTING UP THE WIRELESS THERMOMETER
If you encounter any difficulties in setting up your wireless thermometer
system, please contact Consumer Relations.
• For the first installation, always insert batteries into the home unit
FIRST
and then the remote sensor(s). (See BATTERY INSTALLATION section)
• Now enter the current weather conditions. Press “
MAX/MIN
” to select a
weather condition (sunny, partially sunny, cloudy, rainy, stormy). Press
“
CLEAR
” to confirm your selection. The built in barometer will
automatically adjust to this setting.
• Your new RF Thermometer is built with security code technology, the
home unit will learn the code of the first remote sensor and log it in as
channel 1. Channel 2 and Channel 3 will be registered in the same way
if additional sensors are used. This unit can monitor up to 3 separate
sensors.
• Once a channel is registered, it will not accept any new sensors. However,
registered channels can be erased by removing the batteries in the
remote sensor or the home unit.
•
When replacing batteries for the remote sensor
- Remember to clear the
corresponding channel of the home unit by removing the batteries. –OR–
Select the respective channel of the sensor by pressing the CHANNEL
button. Hold the CHANNEL button for 3 seconds to clear the registration.
• Press the Tx button on the back of remote sensor to verify the RF reception.
• It is recommended to test the units next to each other to ensure that both
the remote sensor and home receiver are properly synchronized.
NOTE: Keep the remote sensor out of direct sunlight and rain. Do not
mount on metal surface.
SETTING THE CLOCK & CALENDAR
1. Hold “
SET
” button for 3 seconds to enter clock set.
2. First, select 12 hour or 24 hour setting using the “
+
,
-
” buttons located
on the back of the home receiver. Press “
SET
” button to confirm your
selection.
3.
Select Year
- Use the “
+
,
-
” buttons located on the back of the home
receiver to adjust year setting. Press “
SET
” button to confirm your
selection.
4.
Select Month
- Use the “
+
,
-
” buttons located on the back of the
home receiver to adjust month setting. Press “
SET
” button to confirm
your selection.
2
3
DWS-210-IB SP\ENG 3/25/05 9:15 AM Page 3
