6
7
Instructions for Use
1. Remove the water tank from the unit by grasping the handle and
turn upside down. Unscrew the cap from the bottom of the water
tank. Hold the tank under cold running water and fill to the
desired level (Fig. 6). DO NOT overfill. When you have f i n i s h e d
filling the tank screw the cap back on and turn over (Fig. 7). Place
water tank back into unit and make sure it is sitting properly &
securely in the cavity. NOTE: Only fill the water tank with cold
water, DO NOT use HOT water.
2. Plug the steamer cord into a 120V AC electrical outlet.
3. Turn the On/Off switch to the On position. The switch will light to
indicate that the garment steamer is on. Steam will be ready in 60
seconds.
4. To steam your garments hold the handle while pressing the Steam
on Demand™ button (Fig. 8). Steam will release in 10 seconds.
To stop steaming release the button.
5. When you are finished with your steaming session place the
On/Off switch in the Off position and remove the plug from the
outlet.
NOTE: Be cautious when handling until steamer has fully cooled.
Cleaning and Maintenance
1. Allow the steamer to cool for at least 30 minutes.
2. Empty any excess water from the water tank and allow it to air dry
before replacing the cap and setting it back in the unit.
3. Empty excess water from the reservoir by removing the drain plug
(Fig. 10) and tipping unit.
S t o r i n g
1. Open the 3 clips (Fig. 2) on the telescopic pole and glide it slowly
to collapse being careful not to pinch your fingers. When it is all
the way down close the 3 clips back into place.
2. Coil the hose and place on the hanger attachment (Fig. 9)
3. Store the cord on the cord wrap attachment.
NOTE: Do not wrap the power cord around the unit.
Handle
Hose
Steam on Demand™ Button
Steamer Nozzle
Hanger Attachment
Pole
Pole Connector
Water Tank
On/Off Switch
Drain Plug
Figure 7
Figure 8
Figure 10
Figure 6
Figure 5
B r u s h
Steam on
C o m a n d ™
B u t t o n
Figure 9
PS300_SPENG 8/1/05 7:23 AM Page 7
