Holztech SD320
WWW.HOLZTECH.COM
5.
Do not push the workpiece with finger tips or hands.
6.
For small workpieces apply auxiliaries
7..
Check up for defects (nails, knots, etc.)
8.
When surface of job is uneven, begin with the side from which less material is removed.
9. By sudden fall of working force e.g. power supply cut off, stop immediately the forward
feed. .
Planing of small workpieces
Take off the knives cover C and place it to the groove guide at distance equal to the width of
the workpiece (fig. l).
Press the workplece with the left hand agalnst tlie groove guide D and feed table A and feed
uniformly with the right hand (Fingers of both hands must be collected in fists and the thumbs
must be on the workpiece - fig. 2 and 3)
When planing small section jobs use an additional angular piece (to avoid accidents). The
knives shield C may serve as groove guide (fig. 4).
