Holztech SD320
WWW.HOLZTECH.COM
9.2. Inserting and setting knives
Clean the following parts:
- chutes of the knives shaft N
- tapered tips (4)
- springs (2)
- connecting bolts (5)
Insert the tapered tips and the planer knives into the chute of the knives shaft and press them
using wooden stick against the springs, after that slightly withdraw the connecting bolts (some
0.2 nun above the top surface of working table B).
Inserting the knives using self-made insertion plate.
*
Place the insertion plate on the lower side of working table B near one of the connecting
bolts.
*
Turn the knives shafts CW until the knives touch the insertion plate and shift the plate to
front. Correct setting is 2-4 mm. When feed is greater the knives sink downwards, when
feed is smaller the knives tend to emerge udwards.
•
Repeat the setting procedure near the next connecting bolt-, then screw boits from inside
to outside (turning moment 9 Nm).
•
Check with the insertion plate the remaining run-outs of the knives.
