Holzstar TKS 200, Instruction Manual

Page: 15 / 34

Assembly
TKS Serie | Version 1.04 15
11.1 Mounting the saw blade
Step 1: Remove the table insert (Fig.20) and loosen the
fixing screw of the saw blade.
Fig. 20: remove the table TKS 200
Step 2: Place the saw blade on the flange and secure it
with the screw. Pay attention to the correct
direction of the saw blade teeth (Fig.21).
Fig. 21: Installation of the saw blade TKS 200
11.2 Assembly and adjustment of the splitting wedge
Step 1: Adjust the riving knife so that its distance from
the saw blade is between 3 and 8 mm. To adjust
the splitting wedge, loosen the screw, bring the
splitting wedge into the correct position and
tighten the nut again.
Fig. 22: Assembly riving knife
Step 2: Check whether the riving knife with the table
insert is parallel to the saw blade (Fig. 23).
Fig. 23: Control riving knife
Step 3: Fit the cover (20) with round head screw M 6 x
25, washer 6 and wing nut M6 to the splitting
wedge (18) (Fig.24).
Fig. 24: Mount cover
11.3Assembly and adjustment of the
longitudinal stop
Step 1: Slide the lengthwise stop into the guide groove
provided for this purpose and fasten it with the
left-hand hexagon socket screw (Fig.25). First
set the longitudinal stop on the stop side in order
to align it exactly with the guide rail to the saw
blade.
Fig. 25: Insertion of the longitudinal stop TKS 200
The longitudinal stop can be moved and rotated by
loosening and turning the lower clamping screw (Fig.
26). It is also possible to use the stop on the left or right
side.
20
18