Holzstar ADH 200, Instruction Manual

Page: 16 / 22

16 ADH-Series | Version 1.05
Troubleshooting
10 Troubleshooting
11 Disposal, recycling of used devices
For environmental benefits it is necessary to ensure that
all components of the machine are only disposed of by
the provided and allowed means.
11.1 Decommissioning
Immediately decommission used machines in order to
avoid later misuse and endangering of the environment
or of persons.
Step 1: Dispose of all environmentally hazardous oper-
ating materials of the used device.
Step 2: If required, disassemble the machine into easy-
to-handle and usable components and parts.
Step 3: Supply the machine components and operating
materials to the provided disposal routes.
11.2 Disposal of electrical devices
Electrical devices include numerous recyclable materi-
als as well as environmentally hazardous components.
These components must be disposed of separately and
professionally. In case of doubt, please contact your
municipal waste management company.
For the recycling process, please request the assist-
ance of a specialized waste disposal centre if required.
11.3 Disposal of lubricants
The manufacturer of the lubricant makes the disposal in-
structions for the used lubricants available. If applica-
ble, ask for the product-specific data sheets.
Malfunction Possible cause Remedy
Engine does not start Power supply is
ON/OFF Switch is defective.
Protektive switch is ON Check the power connection by ex-
pert staff.
Cool the motor, then restart
The motor is runnig, but planer knife
does not turn. The driving is torn Replace the drive belt.
Motor is hot 1. Motor short circuit
2. Motor is overloaded
3. Blunt planer knife
1. Remove the power plug from the
socket and check/repair the
machine by expert staff.
2. Cool the motor.
3. Replace or sharpen the planer
knife.
The motor dies, the workpiece is
burned when planing 1. Blunt planer knife
2. The tool is deformed.
1. Replace or sharpen the planer
knife.
2. Replace the tool.
Handwheels are difficult to move. 1. Dirt or chips in the machine depo-
sit and block the hand wheel.
1. Clean the machine and lubricate
the bearing.