Holzstar 5922201, Operating Instructions Manual

Page: 11 / 20

Installation of the Chip Extraction Unit
SAA Series | Version 1.06 11
8 Installation of the Chip Extraction
Unit
Installation of the casters
Fig. 4: Installation of the casters
To assemble, first place the base plate upside down and
attach the four casters to the holes provided and tighten
with wrench (Fig. 4).
Installation of the fan/motor assembly
Fig. 5: Installation of the fan/motor assembly (1)
Step 1: With the motor base, collector body & fan/motor
assembly in place, secure it to the base plate
using the screw and washers provided as shown
in Fig 5.
Fig. 6: Installation of the fan/motor assembly (2)
Step 2: Install the packing and square connecting tube,
connector to the collector body assembly using
screw and washers provided (Fig 6 & Fig 7).
Fig. 7: Installation of the fan/motor assembly (3)
Step 3: Install the two collectors and two packing to the
outlet (Fig 8).
Fig. 8: Installation of the fan/motor assembly (4)
Installation of the support rods
Fig. 9: Installation of the support rods (1)
Step 1: Install the two collector supports and two upper
bag support (Fig 9).
Fig. 10: Installation of the support rods (2)
Step 2: Next, hang the two bags from the support rods.
Then attach the two filterbags and two collection
bags to the collectors using bag clamp.
Step 3: The inlet can now be placed on the intake hole of
the fan/motor assembly (Fig. 10).
Wear protective goggles!
Wear the protective clothing!
Wear the safety shoes!